Indian sandstone paving

Use, loading and layout

Traditional patios and terraces and garden paths, seating areas and steps can place different demands on the construction. We measure vehicle movements, pedestrian routes, furniture or garden use, then check whether the proposed layout leaves practical access around doors, gates and parked vehicles.

The intended use influences excavation, support, edge restraint and detail around covers or thresholds. It is better to settle those requirements before selecting a colour or pattern.

Finish, colour and detailing

Options can include mixed calibrated paving packs and contrasting brick or stone borders. Samples should be considered beside the property because brick, render, roof colour, shade and surrounding planting can change how a finish looks outdoors.

Borders and transitions are functional as well as decorative. They can define curves, secure an edge, separate materials and make future repairs easier to set out neatly.

Preparation and water management

The starting point is to set out the finished levels, falls, pattern and transitions. We then agree how much existing material must be removed, what supporting layers are required and where excavated material can be handled safely.

Install the prepared base and lay each slab on full, suitable support. Finished levels must protect damp-proof courses and door thresholds while directing rainfall towards a suitable within-boundary route.

Care, repair and realistic expectations

Movement, poor support, unsuitable joint material, contamination and trapped water can contribute. A repair should address the cause, not only refill the visible gap.

We explain routine cleaning, joint or edge checks and any product-specific aftercare before work starts. No outdoor surface is maintenance-free, but good preparation and timely local repairs can prevent small defects becoming disruptive failures.

Assess and set out

Set out the finished levels, falls, pattern and transitions

Prepare and construct

Install the prepared base and lay each slab on full, suitable support

Install and finish

Balance colours and sizes, make accurate cuts and complete the specified joints